Shanghai Duobang Chemical launched a new high-performance, environmentally friendly water-based spray adhesive
2020-01-31
Model: DA-600 Eco-friendly High-Performance Water-Based Spray Adhesive
Main Features: One-component, instant bonding effect, high-temperature resistant above 85°, can withstand long-term water immersion. Long open time, etc.
1. Odorless and pollution-free: No pungent odor like solvent-based spray adhesives
2. No organic solvents: The solvent used is ordinary tap water;
3. No volatile substances: Zero VOC, because "DA-600 Eco-friendly Water-Based Spray Adhesive" does not contain any volatile organic solvents;
4. All raw materials use imported water-based synthetic resins, which are non-toxic.
5. Glue saving: Compared with solvent-based spray adhesives of the same weight, it is more economical. According to customer usage data, the spraying area of "DA-600 Eco-friendly Water-Based Spray Adhesive" can reach more than 3 times that of solvent-based spray adhesives (Note: related to actual operation and spray gun, etc.), truly achieving the dual effect of "environmental protection and economy";
6. High solid content: The solid content of "DA-600 Eco-friendly Water-Based Spray Adhesive" is above 55%, so it is not necessary to spray a thicker layer to achieve good results during use;
1. Clean the surface of the material thoroughly. There must be no grease, dust, or other debris.
2. Spray evenly onto the surface of the material with the nozzle:
3. After even spraying, allow to stand for 2-20 minutes before bonding;
4. Applying appropriate pressure during bonding will improve the bonding effect (some special materials or processes require the glue layer to be dried before heating and pressing. This can be adjusted according to customer requirements);
5. When the spray gun is not used for a long time, clean it with pure water.
1. When using this product, pay attention to even spraying on the surface of the bonded object, but the surface of the bonded object must be dry, clean, and oil-free before spraying, otherwise it will affect the best bonding effect.
2. After spraying is complete, at a temperature above 20℃, leave it for 1 minute or until the glue is not sticky (depending on the workplace, grasp the operation and placement time) before applying pressure to bond. The bonding material should be accurate and stable for the best effect.
3. When using at temperatures below 10℃, the placement time should be extended. Or if you need to meet the operational process requirements, please contact our engineering department for adjustment to ensure the best bonding performance of the product!
4. At temperatures between 10℃ and -10℃ and on rainy or humid days, grasp the optimal bonding time for operation, and pay attention to whether the surface of the material and the bonded object is dry, otherwise it will lead to poor bonding effects.
5. When the weather, climate, etc., objective factors change, if there are any differences in operation, process, or quality, please contact our engineering department in time for timely solutions, so as not to affect production and reduce production efficiency.
Contact Us
Email:
shduobang@163.com
Phone/WeChat:
+86-13651837338
Hotline:
Email: